ALSAN TRAFIK RS 733 Self-Leveling Mortar is created by combining ALSAN TRAFIK RS 733 Part A and ALSAN TRAFIK RS 733 Part B. ALSAN TRAFIK RS 733 Self-Leveling Mortar is a trowel-applied, rapid setting, polymethyl methacrylate (PMMA) resin-mortar used as a thick concrete patch prior to application of the ALSAN RS roofing systems or the ALSAN TRAFIK RS systems. ALSAN TRAFIK RS 733 Self-Leveling Mortar is also used as a traffic wear surfacing applied over ALSAN TRAFIK RS reinforced and unreinforced waterproofing systems.

Installation

Thoroughly mix the entire pail of ALSAN TRAFIK RS 733 Part A (resin) for 2-3 minutes. Remove the ALSAN TRAFIK RS 733 Part B from the 7-gallon plastic pail, then pour ALSAN TRAFIK RS 733 Part A into the 7-gallon plastic pail. Using a slow-speed (200-400 rpm) mechanical mixer with a spiral agitator, slowly add the entire bag of ALSAN TRAFIK RS 733 Part B. Continue mixing for 2-5 minutes or until a smooth lump-free mortar is achieved. The mix ratio is 1 Part A (10 kg) to 2.3 Part B (23 kg).

Pour off and catalyze only the amount of material that can be applied within 10-15 minutes. Add ALSAN RS Catalyst based on published catalyst mixing rates. Once the catalyst is added to the mortar, mix for 2-3 minutes.

Apply the mortar to clean, prepared and primed substrate at the required coverage rate using a pin roller, stub roller, steel v-notch trowel or steel rake. Mortar should be uniformly spread across the substrate and rolled with a pin roller to knock down any high spots.

For complete application instructions refer to the ALSAN TRAFIK RS Trafficable Waterproofing Technical Manual