ALSAN® COATING EPDM PRIMERSKU: L-ACEPDMP

ALSAN® Coating EPDM Primer is a water-based, acrylic primer/basecoat that is VOC compliant, single component, plasticizer-free and used to enhance adhesion and block bleed-through discoloration from new EPDM membranes.

Product Properties

  • Material Primer

Installation

ALSAN Coating EPDM Primer can be applied using single component airless spray equipment, roller or brush. Prior to starting application, perform an adhesion test on each surface type to ensure adequate bond can be achieved or if another primer or other specific surface preparation is required. Do not apply over wet substrates or with risk of precipitation. Protect from freezing during transit, handling, storage, and installation. NOTE: This product cures by water evaporation only and must cure for at least 24 hours. Low temperatures and high humidity will slow the curing process. Product should not be applied when ambient temperature is below 35°F (1.7°C), could fall below 32°F (0°C) within 24 hours of application, or if rain or dew is likely to occur before product dries and/or within 6 hours of application.

Testing & Approvals

Share this page