ALSAN® RS FLEECE SKU: L-RS027B
ALSAN® RS FLEECE SKU: L-RS027B
ALSAN RS FLEECE is a proprietary non-woven, polyester reinforcement used in ALSAN RS roofing and ALSAN TRAFIK RS waterproofing applications. Besides improving membrane strength and durability, polyester reinforcement provides additional puncture resistance and flexural fatigue and crack bridging capabilities. ALSAN RS FLEECE is available in a roll or in pre-cut detail kits for corners and small and large pipes.
Product Properties
- Material Reinforcement
Installation
Mix and apply ALSAN RS products in strict accordance with published instructions. Apply the catalyzed resin to the prepared surface. Place ALSAN RS FLEECE into the liquid resin, ensuring the fleece is smooth and without any wrinkles. The fleece will begin to saturate with the liquid resin. Roll the fleece with a nap roller applying light pressure to eliminate air bubbles, wrinkles, etc. Add additional liquid resin mix on top of ALSAN RS FLEECE until the fleece is fully saturated and the resin layer is uniformly applied. Allow a 2 in (5 cm) overlap at the side laps and 4 in (10 cm) at all flashing tie-ins and end laps.
Testing & Approvals
Related Products
SOPRALASTIC® 123
SOPRALASTIC® 123 is a black waterproofing coating composed of elastomeric bitumen, mineral fillers and solvents. SOPRALASTIC® 123 is used to…
View Product
SOPRALENE® 180 PS 3.0
SOPRALENE 180 PS 3.0 is an SBS-modified bitumen base ply for use in approved multi-ply membrane and flashing assemblies. SOPRALENE…
View Product
SOPRA-XPS 40
SOPRA-XPS 40 are rigid thermal insulation boards made of extruded polystyrene closed-cell foam. It is mainly used for SOPREMA foundation…
View ProductRelated Projects
The Westin Savannah Harbor – Savannah, Georgia
The Westin was due for a roof replacement on 17,828 square feet of its property. To complete the project, SOPREMA’s SOPRAISO ™, DUOTACK®, SENTINEL® P-150, and ALSAN® RS 230 Flash were selected. These products allowed for the design to meet FM 1-120 codes and the use of ALSAN RS 230 Flash solved any difficult flashing details which was only one of many reasons
SOPREMA products were selected.
Northeast Louisiana State Office Building – Monroe, Louisiana
As an approved manufacturer for the State of Louisiana, the decision makers at the Facility Planning and Control Department were assured that the products installed offered unsurpassed quality. The final assembly was designed to meet FM Approvals 1-90 wind uplift test and proves to protect the building for many years to come.