ALSAN® RS 260 LO FIELD SKU: L-RS050S
ALSAN® RS 260 LO FIELD SKU: L-RS050S
ALSAN RS 260 LO FIELD is a high-performance, low odor, rapid-setting, polymethacrylate (PMA) liquid resin. ALSAN RS 260 LO FIELD resin is combined with fleece fabric to form a monolithic, self-flashing and self-adhering reinforced waterproofing membrane. ALSAN RS 260 LO FIELD is available in a summer or winter formulations.
Product Properties
- Installation Method 2 Part
- Material Liquid
- Technology PMA
Installation
Using a slow-speed (200 to 400 rpm) mechanical agitator, thoroughly mix the entire container of resin for two minutes before use. Only catalyze the amount of material that can be used within 10-15 minutes. Add the pre-measured catalyst to the resin component and stir for two minutes and apply to the substrate. Refer to the catalyst information found on the second page of the PDS. Apply without dilution or thinning.
After mixing, apply ALSAN RS 260 LO FIELD to prepared substrate at the required consumption using a roller or brush. The resin should be applied evenly onto the surface using care not to spread too thin or pool in low areas.
Refer to the ALSAN RS Roofing Technical Manual for additional application guidelines.
Testing & Approvals
Related Products
ELASTOCOL™ STICK H2O
ELASTOCOL STICK H2O is a water-based polymer emulsion primer approved for use in roofing, walls and waterproofing assemblies. ELASTOCOL STICK…
View Product
Bitutak Cold Smooth
BITUTAK® Cold is a 3.8 mm (150 mils) APP (Atactic Polypropylene) modified bitumen roofing membrane for approved multi-ply membrane and…
View Product
SOPRALENE® FLAM 250
SOPRALENE® Flam 250 is an SBS-modified bitumen base ply for use in approved multi-ply membrane and flashing assemblies. SOPRALENE Flam…
View ProductRelated Projects
Airport High School – West Columbia, South Carolina
Because of the uneven surface of the remaining embedded aggregate, SOPRAROCK® was chosen knowing that this board would conform to the uneven surface much better than a rigid coverboard could. This idea spawned another....”why not use SOPRASMART® XP”; and allow one application step instead of two. The project was capped off with SOPRALENE® 180 FR GR, in COLPLY® Adhesive.