SOPRAFIX® MBB BATTEN BAR SKU: F357
SOPRAFIX® MBB BATTEN BAR SKU: F357
SOPRAFIX® MBB (Metal Batten Bar) is a flat, nominal 1 inch wide AZ55 Galvalume metal bar with 3″ o.c. pre-punched round holes. MBB is available in 10’ feet or special order lengths.When installing MBB, center the MBB down the middle of the mechanically fastened side lap seam of the SOPRAFIX® field membrane ply. The SOPREMA® #15 or #14 fasteners are installed in the MBB pre-punched holes according to the applicable fastening pattern.
Product Properties
- Type Stress Plate
Installation
When installing MBB, center the MBB down the middle of the mechanically fastened side lap seam of the SOPRAFIX field membrane ply. The #15 or #14 fasteners are installed in the MBB pre-punched holes according to the applicable fastening pattern.
Testing & Approvals
Related Products
SOPRA-EDGE SENTINEL® Fascia
SOPRA-EDGE SENTINEL® Fascia is manufactured in 12 foot lengths with pre-punched fastening holes in the galvanized water dam to ensure…
View Product
TRI-FIXX™ FASTENING SYSTEM
The TriFixx™ Fastening System is a plate/nail combination that is utilized for mechanically attaching SOPREMA™ membranes to lightweight insulating concrete…
View Product
SENTINEL® T-JOINT PATCHES
SENTINEL T-JOINT PATCHES are made using 60 mil, reinforced SENTINEL P150 PVC membrane cut into a perfect 4.5 in-diameter circle….
View ProductRelated Projects
Northeast Louisiana State Office Building – Monroe, Louisiana
As an approved manufacturer for the State of Louisiana, the decision makers at the Facility Planning and Control Department were assured that the products installed offered unsurpassed quality. The final assembly was designed to meet FM Approvals 1-90 wind uplift test and proves to protect the building for many years to come.
Airport High School – West Columbia, South Carolina
Because of the uneven surface of the remaining embedded aggregate, SOPRAROCK® was chosen knowing that this board would conform to the uneven surface much better than a rigid coverboard could. This idea spawned another....”why not use SOPRASMART® XP”; and allow one application step instead of two. The project was capped off with SOPRALENE® 180 FR GR, in COLPLY® Adhesive.