ALSAN® RS 276 PRIMER SKU: L-RS002C
ALSAN® RS 276 PRIMER SKU: L-RS002C
ALSAN RS 276 PRIMER is a rapid-setting, proprietary formulation polymethyl methacrylate (PMMA) primer. ALSAN RS 276 PRIMER is utilized to promote adhesion over concrete, masonry, and other substrates prior to application of ALSAN RS roofing and ALSAN TRAFIK RS waterproofing and flashing systems.
Installation
Using a slow-speed (200 to 400 rpm) mechanical agitator, thoroughly mix the entire container of resin for two minutes before use. Only catalyze the amount of material that can be used within 10-15 minutes. Add the pre-measured catalyst to the resin component and stir for two minutes and apply to the substrate. Refer to the catalyst information found on the second page of this PDS. Apply without dilution or thinning.
After mixing, apply ALSAN RS 276 PRIMER to substrate at the required consumption using a roller or brush. The resin should be applied evenly onto the surface using care not to spread too thin or pool in low areas.
Refer to the ALSAN RS Roofing or ALSAN TRAFIK RS Waterproofing Technical Manuals for additional application guidelines.
Testing & Approvals
Related Products
ALSAN® RS Cleaner
ALSAN RS CLEANER is a solvent-based solution specially formulated to clean and reactivate fully cured, in-place ALSAN RS membranes. ALSAN…
View Product
COLPHENE® BSW-V
COLPHENE® BSW-V is an SBS-modified bitumen, self-adhered waterproofing membrane for use in approved blind side waterproofing assemblies. COLPHENE BSW-V is…
View Product
ELASTOPHENE® FLAM STICK
ELASTOPHENE® Flam Stick is an SBS-modified bitumen, self-adhered base ply for use in approved multi-ply membrane and flashing assemblies. ELASTOPHENE…
View ProductRelated Projects
Northeast Louisiana State Office Building – Monroe, Louisiana
As an approved manufacturer for the State of Louisiana, the decision makers at the Facility Planning and Control Department were assured that the products installed offered unsurpassed quality. The final assembly was designed to meet FM Approvals 1-90 wind uplift test and proves to protect the building for many years to come.
University of Oregon Residence Hall – Eugene, Oregon
With a student population of over 24,000, the University of Oregon was in need of a new residence hall. When selecting an air barrier for the project, it was decided that SOPRASEAL® Stick VP and SOPRASOLIN® HD would be applied.