ANTIROCK® SKU: 01715
ANTIROCK® SKU: 01715
ANTIROCK and ANTIROCK Starter are SBS-modified bitumen membranes designed to waterproof bridge decks. ANTIROCK is composed of a proprietary formulation of elastomeric styrene-butadiene-styrene (SBS) polymer modified bitumen and is reinforced with tough, dimensionally stable non-woven polyester mat. The topside is surfaced with ceramic coated granules and the underside is surfaced with polyolefin burn-off film to facilitate heat welding. ANTIROCK Starter is used as a starting membrane for ANTIROCK and has a with a selvage of 3 in (75 mm) on each side.
Product Properties
- Components Cap Sheet
Installation
ANTIROCK AND ANTIROCK Starter are mechanically fastened (Macaden, Mini-Macaden) or heat-welded with a propane torch. They must be installed by thermofusion on dry and clean surfaces previously primed with ANTIROCK Primer or ANTIROCK Emulsion Primer. Side lap joints must be a minimum of 3 in (75 mm) and end lap joints must be minimum of 6 in (150 mm). Decks that are to be waterproofed with membrane must conform to the specified surface profile (CSP) of 3-5 of the International Concrete Repair (ICRI). Shotblasting is recommended over the entire surface. Refer to SOPREMA’s ANTIROCK specifications for additional application guidelines.
Related Products
2-1 SOPRASMART BOARD
2-1 SOPRASMART BOARD is a high-performance factory laminated panel combining an SBS-modified bitumen base membrane and SOPRABOARD an asphaltic roof…
View Product
ALSAN® COATING AC 401
ALSAN COATING AC 401 is a high quality, single component, water-based, acrylic elastomeric roof coating and protective barrier for…
View Product
SOPRASEAL® Xpress G Screws
SOPRASEAL® Xpress Screws are self-drilling screw fasteners specifically designed for the installation of SOPRASEAL® Xpress G boards. SOPRASEAL® Xpress G…
View ProductRelated Projects
John R. Oishei Children’s Hospital – Buffalo, New York
SOPREMA’s SOPRASEAL® Xpress G air and vapor barrier was ideal for this project. The exterior grade, inorganic faced gypsum board with an air and vapor barrier factory applied to the exterior surface, is the first and only ABAA evaluated assembly. SOPRASEAL® Xpress G boards are mechanically fastened to the structure using corrosion resistant SOPRASEAL® Xpress G Screws. A 6 inch self-adhered strip of SOPRASEAL® Stick 1100T is then installed over all board joints.
U.S. Treasury Building – Washington DC
The Treasury Building is the oldest departmental building in Washington and has had a great impact on the design of other governmental buildings. At the time of its completion, it was one of the largest office buildings in the world.