Search

COLVENT™ FLAM 180 TG SKU: 00375

COLVENT™ FLAM 180 TG SKU: 00375

COLVENT Flam 180 TG (torch grade) is an SBS-modified bitumen vented base ply for use in approved multi-ply membrane and flashing assemblies. COLVENT Flam 180 TG is reinforced with a tough, dimensionally stable non-woven polyester mat that is saturated and coated on both sides with a proprietary formulation of elastomeric styrene-butadiene-styrene (SBS) polymer modified bitumen.

Product Properties

  • ASTM ASTM D6164
  • Component Base
  • Installation Method Heat Welded
  • Reinforcement Polyester
  • Thickness (minimum) 110 mils (2.8 mm)
  • Thickness (nominal) 118 mils (3.0 mm)
  • Topside Burn Off Film
  • Underside Burn Off Film

Installation

Prior to installation, unroll COLVENT Flam 180 TG onto the roof surface and allow to relax. Place COLVENT Flam 180 TG in desired position and back roll the product. COLVENT Flam 180 TG is then heat welded to approved substrates. Subsequent approved inter-ply or cap ply membranes are applied to COLVENT Flam 180 TG via heat welding.

 

Testing & Approvals

Related Products

ELASTOPHENE® HS SANDED

ELASTOPHENE HS Sanded (high strength) is an SBS-modified bitumen base ply for use in approved multi-ply membrane and flashing assemblies….

View Product

ELASTOPHENE® FLAM HS

ELASTOPHENE® Flam HS (high strength) is an SBS-modified bitumen base ply for use in approved multi-ply membrane and flashing assemblies….

View Product

SOPRA™ 4897

SOPRA 4897 is an SBS-modified bitumen venting base sheet for use in approved multiply membrane and flashing assemblies. SOPRA 4897…

View Product

Related Projects

Denver Union Station – Denver, Colorado

When the Denver Union Station was to go through a remodel, SOPREMA’s COLPHENE® BSW product was selected to waterproof the building.
In 2011, SOPREMA met the challenges of waterproofing the building envelope with the COLPHENE BSW system to ensure a seamless watertight solution. Over 170,000 sq ft of COLPHENE BSW was used as a waterproofing membrane.

Fayetteville Area System of Transit Multimodal Project – Fayetteville, North Carolina

The original design selected for the center left the project over budget, so the contractor and architect had to go back to the drawing board. After researching additional options, both Baker Roofing and Gantt Huberman Architects felt very comfortable with SOPREMA’s proven history and the ability to meet the Buy American requirement, so they selected the SENTINEL® line for the project.