SOPRAFIX® BASE 613 SKU: 00423
SOPRAFIX® BASE 613 SKU: 00423
SOPRAFIX BASE 613 is an SBS-modified bitumen membrane designed specifically for mechanical attachment to approved roof decks. SOPRAFIX BASE 613 is reinforced with a tough, dimensionally stable non-woven polyester mat that is saturated and coated on both sides with a proprietary formulation of elastomeric styrene-butadiene-styrene (SBS) polymer modified bitumen.
Product Properties
- ASTM ASTM D6164
- Component Base
- Installation Method Mechanically Attached
- Reinforcement Polyester
- Thickness (minimum) 110 mils (2.8 mm)
- Thickness (nominal) 118 mils (3.0 mm)
- Topside Burn Off Film
- Underside Burn Off Film
Installation
Prior to installation, unroll SOPRAFIX BASE 613 onto the roof surface and allow to relax. Place SOPRAFIX BASE 613 in desired position. SOPRAFIX BASE 613 is mechanically fastened through the 5-inch side laps using the appropriate fastener. Subsequent approved inter-ply or cap ply membranes are applied to SOPRAFIX BASE 613 via heat welding.
Testing & Approvals
Related Products
ALSAN TRAFIK EP 140
ALSAN TRAFIK EP 140 is a two-component, high solids, low odor, liquid applied epoxy primer. This primer provides excellent adhesion…
View Product
SOPRANATURE® SOPRAFILTER
SOPRANATURE SOPRAFILTER is a fabric made of a non-woven needle punched polypropylene and polyester fibers. SOPRANATURE SOPRAFILTER is used as…
View Product
ALSAN® COATING AC 401 FLASHING
ALSAN COATING AC 401 FLASHING is a high quality, fiber-fortified, water-based, acrylic elastomeric roof mastic. Upon cure, ALSAN COATING AC…
View ProductRelated Projects
Strongsville Starbucks®- Strongsville, Ohio
Roof Rite, the roofing contractor on the job, brought SOPREMA products into the mix based on the wide product selection and proven past performance.
Northeast Louisiana State Office Building – Monroe, Louisiana
As an approved manufacturer for the State of Louisiana, the decision makers at the Facility Planning and Control Department were assured that the products installed offered unsurpassed quality. The final assembly was designed to meet FM Approvals 1-90 wind uplift test and proves to protect the building for many years to come.